Our DG 808 is a modern hig performance glider with very good versatile flying qualities. The computed airfoil of thickness 11-under 9% is perfectly suited for this use and allows a wide speed range. Circling with the DG 807 in a weak thermal lift is easy, and due to its low drag and excellent conversion between altitude and speed it is perfectly suitable for aerobatics and high speed flight. Flaps and ailerons are hinged at the lower side, hence touching down at the slope is comfortable thanks to the crow configuration of the flaps.
With a mass of only 16 kg for the DG 808 is very light, and fitted with a jetec 120 it is able to
self-launch on a grassy runway. Because of the thin airfoil the wing is built in an all carbon hard shell
technique, and the square wing joiner of dimensions 20x50 mm is made of carbon, too. The stability of the
wing is very high and well suited for velocities above 300 km/h even at demanding conditions.
price: on request All photos of the DG808...
For price inquiries and offers please contact us by MAIL.
|wing span||6000 mm|
|fuselage length||2350 mm|
|takeoff weight glider without landing gear||from 13 kg|
|takeoff weight complete with drive jetec120pro (12S 5000mA) excellent for grass slopes!||from 16 kg|
|airfoil thickness||10% - 9%|
|center of gravity||88 mm without wing (with elevator)|
|Included flap (2 flaps)
In normal flight switch off the flap.
↑ 13 mm↓ 8 mm Inner side measurement
↑ 10 mm↓ 5 mm Aileron measured outside
|Thermal and speed aerobatic|
↓ 8 mm Flap Inner side measurement
↓ 1 mm Aileron measured outside
↑ 2 mm Flap Inner side measurement
↑ 1 mm Aileron measured outside
↓ max Flap Inner side measurement Please check that the servo has the
mechanical end and the mylar tape is inside.
↑ 3 mm Aileron measured outside
↓ 8 mm Elevator mix measured inside
|↑ 20 mm↓ 17 mm measured inside|
|40 mm measured on top|
|All dimensions in millimeters (mm).|
The specified values result in very agile flight behavior. Individual deviations are possible. RAL color 9003 (white). Attention, please clean the varnish only with polish (no acetone or spirit) !!!
|KST X10 10mm||2x Aileron, 1x Brake|
|Servo Jeti J3D13T 15mm||13 kg||1x Elevator|
|KST A15 1810||2x Flap, 1x Tow release, 1x Rudder, 1x Gear|